Practice Examples and Dumps & Tips for 2024 Latest NSE7_SDW-7.0 Valid Tests Dumps
Latest [Apr 23, 2024] 100% Passing Guarantee - Brilliant NSE7_SDW-7.0 Exam Questions PDF
NEW QUESTION # 25
Refer to the exhibits.
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. London generates an IKE information message that contains the Toronto public IP address.
- B. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- C. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- D. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
Answer: C,D
NEW QUESTION # 26
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
- A. set-route-tag
- B. holdtime-timer
- C. update-source
- D. link-down-failover
Answer: B,D
NEW QUESTION # 27
Refer to the exhibit.
Which statement about the role of the ADVPN device in handling traffic is true?
- A. Two spokes, 192.2.0.1 and 10.0.2.101, forward their queries to their hubs.
- B. This is a hub that has received a query from a spoke and has forwarded it to another spoke.
- C. This is a spoke that has received a query from a remote hub and has forwarded the response to its hub.
- D. Two hubs, 10.0.1.101 and 10.0.2.101, are receiving and forwarding queries between each other.
Answer: B
NEW QUESTION # 28
Refer to the exhibit.
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
- A. add-route must be disabled.
- B. mode-cfg must be enabled.
- C. exchange-interface-ip must be enabled.
- D. type must be set to static.
Answer: A
Explanation:
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236
NEW QUESTION # 29
Exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The packet size exceeded the outgoing interface MTU.
- B. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- C. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- D. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
Answer: B
NEW QUESTION # 30
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. Changes have been made on firewall policy ID 1 on FortiGate.
- B. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- C. FortiGate has terminated the session after a change on policy ID 1.
- D. Firewall policy ID 1 has source NAT disabled.
Answer: A
NEW QUESTION # 31
Refer to the exhibits.
Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)
- A. The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NPU.
- B. The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.
- C. On the sender FortiGate, duplication-max-num is set to 3.
- D. On the receiver FortiGate, packet-de-duplication is enabled.
Answer: C,D
NEW QUESTION # 32
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Use different proposals are used between the interfaces.
- B. Use unique Diffie Hellman groups on each VPN interface.
- C. Specify a unique peer ID for each dial-up VPN interface.
- D. Configure the IKE mode to be aggressive mode.
Answer: C,D
NEW QUESTION # 33
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Reverse-policy shaping mode
- B. Shared-policy shaping mode
- C. Interface-based shaping mode
- D. Per-IP shaping mode
Answer: C
Explanation:
Explanation
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.
NEW QUESTION # 34
Refer to the exhibit.
An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)
- A. T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
- B. The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
- C. T_INET_0_0 does not have a valid route to the destination.
- D. T_INET_1_0 has a higher member configuration priority than T_INET_0_0.
Answer: B,C
Explanation:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Assigning-Priority-to-SD-WAN-Members-for-Default/ta-p/230911
NEW QUESTION # 35
Which two statements about SLA targets and SD-WAN rules are true? (Choose two.)
- A. When configuring an SD-WAN rule, you can select multiple SLA targets of the same performance SLA.
- B. SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements.
- C. SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy.
- D. Member metrics are measured only if an SLA target is configured.
Answer: B,C
NEW QUESTION # 36
Which two interfaces are considered overlay links? (Choose two.)
- A. LAG
- B. Physical
- C. IPsec
- D. GRE
Answer: C,D
NEW QUESTION # 37
Which two statements about SD-WAN central management are true? (Choose two.)
- A. The objects are saved in the ADOM common object database.
- B. It does not support meta fields.
- C. It supports normalized interfaces for SD-WAN member configuration.
- D. It uses templates to configure SD-WAN on managed devices.
Answer: A,D
Explanation:
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template-fmg
NEW QUESTION # 38
Refer to the exhibits.
Exhibit A
Exhibit B -
Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.
The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.
Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?
- A. The traffic will be routed over T_INET_1_0.
- B. The traffic will be routed over T_INET_0_0.
- C. The traffic will be routed over T_MPLS_0.
- D. The traffic will be load balanced across all three overlays.
Answer: A
NEW QUESTION # 39
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
- A. Destination internet service must be enabled on the traffic shaping policy.
- B. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
- C. Web filtering must be enabled on the firewall policy.
- D. Application control must be enabled on the firewall policy.
Answer: D
NEW QUESTION # 40
What are two benefits of using forward error correction (FEC) in IPsec VPNs? (Choose two.)
- A. FEC transmits parity packets that can be used to reconstruct packet loss.
- B. FEC supports hardware offloading.
- C. FEC improves reliability of noisy links.
- D. FEC can leverage multiple IPsec tunnels for parity packets transmission.
Answer: A,C
NEW QUESTION # 41
Refer to the exhibit.
Based on the exhibit, which action does FortiGate take?
- A. FortiGate brings down port5 after it detects all SD-WAN members as dead.
- B. FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.
- C. FortiGate bounces port5 after it detects all SD-WAN members as dead.
- D. FortiGate brings up port5 after it detects all SD-WAN members as alive.
Answer: B
NEW QUESTION # 42
In a hub-and-spoke topology, what are two advantages of enabling ADVPN on the IPsec overlays? (Choose two.)
- A. It provides the benefits of a full-mesh topology in a hub-and-spoke network.
- B. It enables spokes to establish shortcuts to third-party gateways.
- C. It enables spokes to bypass the hub during shortcut negotiation.
- D. It provides direct connectivity between spokes by creating shortcuts.
Answer: A,D
NEW QUESTION # 43
......
Fortinet NSE7_SDW-7.0, also known as the Fortinet NSE 7 - SD-WAN 7.0 exam, is a certification program offered by Fortinet. NSE7_SDW-7.0 exam is designed to test the knowledge and skills of IT professionals who work with Fortinet's software-defined wide area network (SD-WAN) solutions. Fortinet NSE 7 - SD-WAN 7.0 certification program is aimed at network engineers, architects and administrators who want to prove their expertise in deploying, configuring and managing Fortinet SD-WAN solutions.
NSE7_SDW-7.0 are Available for Instant Access: https://www.torrentvalid.com/NSE7_SDW-7.0-valid-braindumps-torrent.html
NSE7_SDW-7.0 Certification – Valid Exam Dumps Questions Study Guide: https://drive.google.com/open?id=1sfEkJD8sO1kOIst5LXATRb58OY20QD4h