Get Network Appliance NS0-176 Dumps Questions [2021] To Gain Brilliant Result
NS0-176 dumps - TorrentValid - 100% Passing Guarantee
NEW QUESTION 62
Which type of pools do you need to create vHBA templates?
- A. WWPN
- B. MAC
- C. WWNN
- D. IQN
Answer: A
NEW QUESTION 63
Which two are correct about VSAN configuration within UCS Manager? (Choose two)
- A. VSAN ID and FCoE VLAN ID have to match.
- B. In addition to SAN tab, VSANs can be configured under UCSM Server tab as well.
- C. VSAN IDs 3840-4079 are not available regardless of the Fabric Interconnect mode.
- D. VSAN can be configured as fabric interconnect specific.
- E. We can delete VSAN 1.
- F. VSAN can be configured as a global parameter.
Answer: D,E
NEW QUESTION 64
Given the following switch output, where would you expect see notification level messages?
N5K-1# show logging info.
Logging console: enabled (Severity: error)
Logging monitor: enabled (Severity: informational)
Logging linecard: enabled (Severity: emergency)
Logging fex: enabled (Severity: notifications)
Logging time stamp: seconds
Logging server: disabled
Logging logfile: enabled
- A. Notification messages will not be seen anywhere
- B. On the linecard
- C. On the terminal sessions
- D. On the console
Answer: C
NEW QUESTION 65
Exhibit:
Your vSphere host is booting off an SD and is displaying the error shown in the exhibit.
What should you do to correct the problem?
- A. Enable Unified Extensible Firmware Interface (UEFI).
- B. Enable SD card mirroring.
- C. Reinstall ESXi on a larger SD card.
- D. Update the current ESXi scratch location.
Answer: D
NEW QUESTION 66
Exhibit:
An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The UCS blade servers are configured for SAN boot, and all zoning and LUN mapping for a single 50 GB LUN have been configured.
When selecting the install disk during the Windows installation, the symptoms and error shown in the exhibit are displayed.
What should the administrator do to solve the problem?
- A. Delete the extra LUNs that were created.
- B. Install the Cisco VIC storage miniport driver for Windows 2012 R2.
- C. Configure a single path to the LUN for the duration of the Windows installation process.
- D. Change the LUN OS type to oeWindows 2008 or later.
Answer: B
NEW QUESTION 67
VMware ESXi 6 supports which three storage protocols? (Choose three.)
- A. NFS
- B. FCP
- C. SMB
- D. CIFS
- E. iSCSI
Answer: B,D,E
NEW QUESTION 68
An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The hypervisor will be using CIFS shares for Cluster Shared Volume (CSV) datastores. A storage virtual machine (SVM) is configured, and a CIFS share is created for use.
When attempting to add the CSV datastore to the CIFS share, an error occurs and the datastore is not created.
Which three steps should the administrator perform to solve the problem? (Choose three.)
- A. Configure the export policy with the Hyper-V host IP address.
- B. Configure the ~-smb3-enabled~ parameter on the SVM.
- C. Create multiple LIFs for CIFS Hyper-V traffic to enable ALUA.
- D. Enable the "Continuous Availability" setting on the CIFS share.
- E. Configure the "Enable Oplocks" setting on the CIFS share.
Answer: A,B,E
NEW QUESTION 69
Which service may be used to manage users and groups in a vSphere environment?
- A. VMware vSphere Storage APIs for Array Integration (VAAI)
- B. Microsoft Active Directory (AD)
- C. Network Time Protocol (NTP)
- D. Domain Name System (DNS)
Answer: B
NEW QUESTION 70
Which two are required for single-wire management for Cisco UCS C-Series? (Choose two)
- A. 10 GB LOM
- B. FI 6200 family only
- C. VIC 1240
- D. Redundant Nexus 2232PP FEX
- E. VIC 1225
- F. UCS Manager 2.1 or higher
Answer: E,F
NEW QUESTION 71
Exhibit:
Referring to the exhibit, which two diagrams show the correct way to cable a new NetApp clustered Data ONTAP cluster with two nodes? (Choose two.)
- A. II
- B. I
- C. IV
- D. III
Answer: A,D
NEW QUESTION 72
An administrator has a FlexPod solution using VMware vSphere 6.0. The ESXi hosts use iSCSI for storage connectivity, and all paths have been configured and connected between the NetApp cluster and the ESXi hosts.
Virtual Storage Console has been installed and ESXi host-recommended settings have been applied to all hosts. The active LUN path for one of the iSCSI datastores experiences a connectivity failure and the LUN switches to a new active path.
In this scenario, which event would trigger the ESXi host to switch the active LUN path again?
- A. The ESXi host scans for new VMFS datastores.
- B. The NetApp LIF is reverted to its home port.
- C. The original LUN path comes back online.
- D. The host processes 1,000 I/O operations.
Answer: B
NEW QUESTION 73
Which FlexPod management tool allows you to manage Storage Virtual Machines (SVMs) and replication relationships?
- A. OnCommand Insight
- B. OnCommand Performance Manager
- C. OnCommand System Manager
- D. OnCommand Balance
Answer: C
NEW QUESTION 74
When using Clustered Data ONTAP 8.1 and later, what is the default for new aggregates?
- A. 64-bit aggregates
- B. Vserver aggregates
- C. cluster aggregates
- D. 32-bit aggregates
- E. 128-bit aggregates
- F. traditional aggregates
Answer: A
NEW QUESTION 75
Where are log files located on a NetApp node?
- A. /etc/mlog/
- B. /log/core/
- C. /mroot/etc/log/mlog/
- D. /mroot/etc/crash/
- E. /letc/log/crash
Answer: C
NEW QUESTION 76
When configuring a FlexPod environment for iSCSI boot with Cisco UCS, which item should be preconfigured?
- A. WWPN Pools.
- B. All zoning should be configured.
- C. Zonesets should be created.
- D. IQN and IP address of target.
Answer: D
NEW QUESTION 77
......
Get 100% Passing Success With True NS0-176 Exam: https://www.torrentvalid.com/NS0-176-valid-braindumps-torrent.html